[AI] strange problem with k1000.

Viraj vkafle at gmail.com
Sun Feb 17 01:02:30 EST 2008


One thing I forgot to mention. Having edited the corrections list, be sure 
to apply it in the document by clicking Apply Corrections in the Tools menu. 
You'll get the option only when a file is open.
----- Original Message ----- 
From: "Viraj" <vkafle at gmail.com>
To: <accessindia at accessindia.org.in>
Sent: Sunday, February 17, 2008 11:03 AM
Subject: Re: [AI] strange problem with k1000.


>I have faced such problems even in earlier versions and have been unable to 
>come up with definite solutions. However, one can try the following:
>
> 1. Switch to Fine reader engine if one is using RTK or Scansoft.
> 2. Try switching to Grey Scanning mode.
> 3. Click Edit Corrections in the Tools menu, press Add, enter the word as 
> it is being recognised, such as, odier, and press OK. Now enter the 
> correct word, (other in this instance). Edit all other words that often 
> gets misrecognised in the same way. But sometimes this can result in the 
> replacement of actually correct words with wrong words. For instance, if 
> the program learns to recognise all di as th, then actual words with di 
> will also be converted into th (like the word die will be converted into 
> the). However, what one can do (though it does not guarantee 100 per cent 
> success) is to enter the entire word in the edit corrections list, instead 
> of letter combination, for instance, odier and other instead of di and th.
> 4. One can also try the Replace All command (control H). But here also one 
> should be careful to replace the entire wrong word instead of letter 
> combinations, else one will get wrong results. one can try enabling the 
> Match Whole Word option in the Rplace dialogue box.
>
> One can never hope that issues wil be resolved for good through these 
> steps, but one can always try.
>
>     Please note that the menu commands described above are based on 
> version 9. Look around if version 11 has different menu arangements.
> ----- Original Message ----- 
> From: "Mahesh Panicker" <maheshspanicker at gmail.com>
> To: <accessindia at accessindia.org.in>
> Sent: Saturday, February 16, 2008 9:48 PM
> Subject: [AI] strange problem with k1000.
>
>
>> Hi list.
>> I am facing a strange problem with Kurzweil1000 version 11. when I scan a
>> document, the letter combination TH gets recognized as DI. for EG, the 
>> word
>> that gets recognized as diat.
>> what can be the sorce of this particular problem? how can it be 
>> addressed?
>> looking forward to your suggestions.
>> thanks in advance.
>>
>>
>> -- 
>> Mahesh S. Panicker
>> room no. 121;
>> Kaveri-hostel;
>> Jawaharlal Nehru university new delhi 110067 india.
>> To unsubscribe send a message to accessindia-request at accessindia.org.in 
>> with the subject unsubscribe.
>>
>> To change your subscription to digest mode or make any other changes, 
>> please visit the list home page at
>> 
>> http://accessindia.org.in/mailman/listinfo/accessindia_accessindia.org.in
> 





More information about the AccessIndia mailing list